Products Category

Product Search

Name: Mavis Fu
Tel: 0086-564-3286491
Fax: 0086-564-3286492
Mobile: 008615856460059
E-mail: mavis.gearbox@gmail.com
Add: Shouchun Road, Lu'an Economic Development Zone, Anhui, China

Your location:Home> Product > K series Helical Beve Gearmotor

Hollow Shaft Helical Bevel Gear Reduction Motor with Output Flange

Product name：Hollow Shaft Helical Bevel Gear Reduction Motor with Output Flange

Item：KAF series / KVF series

Details：

Hollow Shaft Helical Bevel Gear Reduction Motor with Output Flange

Description:

Helical bevel geared motors are angular geared motors where the gear unit output shaft is rotated through 90° to the motor shaft. Helical bevel geared units can either have a solid or a hollow shaft. Helical bevel geared motors represent the ideal solution for drive tasks where an angular geared motor with high power density is required with continuously high output torques.

FLK helical bevel geared motors are available in the power range up to 200 kW and rated gear unit torques up to 20,000 Nm.

The geared motors are available in the following versions:

Foot or flange-mounting versions
Version with torque bracket
Solid or hollow shaft
Hollow shaft with key connection, shrink disk, splines

The following table shows possible helical bevel gear unit variants:

Designation	Description
K..	Foot-mounted
KA..B	Foot-mounted / hollow shaft
KV..B	Foot-mounted / hollow shaft / splined hollow shaft
KH..B	Foot-mounted / hollow shaft / shrink disk
KF..	B5 flange-mounted design
KAF..	B5 flange-mounted / hollow shaft
KVF..	B5 flange-mounted / hollow shaft / splined hollow shaft
KHF..	B5 flange-mounted / hollow shaft / shrink disk
KA..	Hollow shaft
KV..	Hollow shaft / Splined hollow shaft
KH..	Hollow shaft / shrink disk
KT..	Hollow shaft / Tork arm
KAZ..	B14 flange-mounted / hollow shaft
KVZ..	B14 flange-mounted / hollow shaft / splined hollow shaft
KHZ..	B14 flange-mounted / hollow shaft / shrink disk

Standard Features:

Reducers

Gears manufactured from certified steel, heat treated to a case hardness of 58-62 for long gear life.
Finished ground or shaved gear teeth to assure maximum mechanical efficiency (1-1/2% loss/gear stage) with low noise and heat.
High capacity anti-friction bearings submerged in oil and splash lubricated for optimum load carrying capacity and long life.
Captured keys on output shafts.
Gearcases made of high strength gray cast iron
High cross-section modulus design, with center wall for maximum rigidity.
Available with inch dimension, hollow or solid output shafts.

Motors